Basic operation, Setting the impedance select switch, High-75 – Toshiba CM1910A User Manual
Page 5: Video, Turning the video monitor on, Adjusting the volume, Adjusting the picture, G d q_qj
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Basic Operation
Setting the impedance select switch
When the VIDEO OUT jack is used to connect another video monitor, set the
impedance select switch to HIGH (left) position.
When the VIDEO OUT jack is not used, set the switch to 75D (right) position.
HIGH-75
VIDEO
Turning the video monitor on
Press the POWER button to turn the video monitor on.
To turn the video monitor off, press the button again.
Adjusting the volume
To increase the volume, press the VOLUME A button. To decrease the volume, press
the VOLUME ▼ button. Press and hold either button until your desired volume level
is obtained.
MENU TVOLUMEA
g D Q_QJ
b
Note: The VOLUME TA buttons will operate as the menu < > buttons while the
menu display is on the screen.
-
5
-