Toshiba CZ 36T31 - Manual (Page 11)

Programming the Remote Control
• This Remote Control is preprogrammed to operate TOSHIBA VCR's.
• To use VCR's other than TOSHIBA models (or cable converter), perform the following procedures before
operating.
Controlling other brands of VCR's and cable TV converters
1 Refer to the "VCR code table" (or "Cable TV converter code
table' ' ) on pages 12 and I to hnd the code mimher thai corresponds to
the brand name of your Vt R (oi'con\ertei ).
If more thtin one ruimher is listed, try etieli one septirateb' tmtil you find
the one that works,
2
Set tlie TV/CABLEA/CR switch to "V'CR'' (or ■‘C.’\BLh”).
3
I lold down RECALL while pressing the Number buttons for the three
digit code number for your brand of VCR (or converter).
4 I’oint the Remote Control at the VCR (or at the converter) and press
POWER to test the code number.
-If the right Duinher was entered, the VCR (or the converter) should ,
tLirn off. -
-If the VCR {or the converter) does not respond to the Remote
Control, repeat steps 1 to 4 with another code nutnber.
5
Reset the TV/CABLEA/CR switch to ‘TV" to control the TV.
For future reference, write down the code numbers you used:
VCR CODE_________________________________________
CABLE CODE
Notes:
• You have !o reprogrtiiii the Remote Control irlteii von chemge its batteries.
• Some never !'CR s are capable of working on either of two remote codes. These
VCR's have a .switch labeled ''VCR1/VCR2 ".
Ij your VCR ba.\ this kind of .switch, and does not re.spoiid to all the cotie numbers
/or your VCR brand name, set the .switch to another position ("VCRI "or "VCR2")
and reprogram the Remote Control.
1 1