VTech 900I - Manual (Page 13)

mGRmmEPHOlAN^MGDraCfilTADl-OPEMTO^
Message Playback Keys
ERASE ........
• The ERASE key is used to delete old
messages (previously reviewed) from
the ITAD.
• Pressing ERASE during message
playback deletes that message.
• If this key is pressed and held for more
than 2 seconds, all old (previously
reviewed) messages in the current
mailbox selection will be deleted (This
feature works only when the
answering machine is idle; it does not
work during message playback).
• To prevent accidental deletion of new
messages, you are not able to delete
a message unless it has been listened
to first!
ERASE
• TO REPLAY
CURRENT PLAYING
MESSAGE :
Q PRESS <yi3 I q
• TO REPEAT
PREVIOUS
MESSAGE
PRESS
REPEAT
• The REPEAT key is used to return to
the beginning of a message during
message playback.
• If this key is pressed prior to a
message, the previous message will
begin.
• The previous message will also begin
if this key is pressed twice quickly
during message playback. •
STOP
• TO STOP MESSAGE
PLAYBACK
• TO STOP MEMO
RECORDING
• TO STOP ANNC.
RECORDING
• TO EXIT SET-UP
MODE
PRESS
STOP
•The STOP key is used to exit the
current mode of operation and return
to the ITAD Standard operationmode.
• Use STOP to stop message playback,
stop memo or announcement
recording, or exit the set-up mode.
PLAY
•The PLAY key is used to begin
playback of all messages/memos
(new and old) in the current mailbox
selection (the default mailbox
selection is All).
• This key is also used to play the
current announcement message by
pressing and holding it for more than
2 seconds.
SKIP
I TO PLAY NEXT
MESSAGE:
PRESS
SKIP
•The SKIP key advances to the
beginning of the next message during
message playback.
INITIAL SET-UP
Press the SETUP key for more than 2
seconds to enter the set-up mode or
until it beeps once. Here you can set
the ring type, security code, time/day
and mailbox programming as follows.
Ring Type Programming
The ITAD has 3 ring type settings:
2 rings The incoming call is
answered after 2 rings.
4 rings The incoming call is
answered after 4 rings.
Toll Saver The incoming call is
answered after 2 rings only
if there are new messages/
memos
present in
memory; otherwise,
answers call after 4 rings.
Thus, if Toll Saver is active
and your ITAD rings 3
times when you call, you
can hang-up to avoid any
long distance charges.
To change ring type setting:
1. Press and hold the SETUP key for
2 seconds. The ITAD will beep and
the LCD will display "rt"(ring type)
and the current ring type setting.
2. Use the REPEAT and SKIP keys to
scroll to the desired ring type.
Forward selection is in the following
order 2 rings, 4 rings, Toll saver.
3. Press the SETUP key to exit ring
type programming mode, and
advance
to security code
programming, or press the STOP
key to exit the set-up mode, and
Security Code Programming
The security code programmed into
the ITAD is used to gain access to the
functions from remote locations.
The security code default setting is 99.
22 23