JVC LVT1089-001B - Manual (Page 7)

<D INPUT LEVEL control
0 Cassette operation buttons (deck B)
Press to wind the tape quickly from right
to left.
Press to wind the tape quickly from left to
right.
Press to stop the tape.
Also press to stop both decks simulta­
neously during dubbing.
Press to start playback/recording.
Press the PLAY button while pressing
this button to start recording, and press
to leave an appropriate non-recorded
section. (Seepage?.)
Press to stop the tape temporarily during
recording and playback.
Press the PLAY button to release the
pause mode.
Press to change the direction of tape
travel.
0 A ► B SYNCHRO DUBBING buttons
Press to dub from deck A to deck B.
• NORM SPEED : Press to perform normal-speed dubbing.
• HIGH SPEED : Press to perform high-speed dubbing.
AUTO REVERSE OPERATION
The auto reverse operation of this unit turns the tape transport
over to the reverse of forward direction automatically when the
tape reaches its end during recording or playback.
• Because of cassette shell construction, a tape recorded in the
forward direction should be played back in the same direction
to obtain stable sound reproduction.
• During recording, auto reverse can be activated only from the
forward to the reverse direction. For good sound quality and to
avoid accidental erasure of previously recorded material,
always start recording with the side A of the tape facing out.
PLAYBACK
(stop)
PLAY
• REC/
REC MUTE
II PAUSE
(direction)
Playback of deck A
Operate in the order of the numbers in the illustration.
O Turn the power on.
0 Load a prerecorded cassette with side A facing out.
o Select the side to be played back.
Side A... Forward direction (PLAY ^)
Side B... Reverse direction PLAY)
O Set the DOLBY NR switch to the same setting as when the
tape was recorded.
0
Select the REVERSE MODE switch as desired.
0
Press the PLAY button of deck A to start playback.
• When the deck contains a tape, the deck is turned on auto­
matically and the tape is played back by only pressing the
PLAY button.
Playback of deck B
Perform steps
0
to
0
of the above procedure for deck B.
Continuous play
First set the REVERSE MODE switch to o.
Load cassette tapes in both decks and press the PLAY button of
the deck to be played first for continuous play of both decks.
• At this time, the CONT indicator lights in the multimode display.
When the tape in the deck which plays first reaches the end of
side B (in the reverse direction), it automatically switches to the
forward direction and enters the standby mode. At the same
time, the other deck starts playback. These operations con­
tinue between decks A and B.
- 5 -