Toshiba TEC EMl-31055 User Manual
Page 13
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
• Label (for Batch printing mode) and Report Paper Threading
EMi-31055
Roll stopper
10. NOTES BEFORE STARTING OPERATION
(1) Be sure to plug the power plug into an AC outlet.
(2) When the power switch is turned on, the scale goes through the test scanning sequence, such as
0000,
0000, 0000, then 1 1 1 1 , 1 1 1 1 , 1 1 1 1 1...... and zeros appear on the displays.
(3) While the scale is in the test sequence, do not put anything on the platter.
(4) Do not move the unit while it is in operation. Should it become necessary to move it at any time,
turn the power switch to the OFF position and be sure to readjust the level indicator after relocaitng
the scale.
(5) Should a power failure occur during operation, remove the commodity from the platter and insert
the power plug into an AC outlet again when power is restored.
(6) If the scale is used with an unrated power source, inaccurate scaling or other errors may occur.
(7) If the Zero Point has shifted during scaling, and no tare is displayed, adjust the Zero Point by
depressing the Zero key.
- 10 -