Toshiba TEC MA-227-100 - Manual (Page 60)

E01-11004
9. READ (X) AND RESET (Z) REPORTS
The following table shows available reports and the the key operations to issue those reports. The
contents of the X and Z reports are the same if both are available, except that:
1) Symbol X for X (read) reports, and Z for Z (reset) reports are printed as the header.
2) A reset count is printed near the end of a Z report (but not on X reports).
3) All the resettable counters and totals will be reset on a Z report issuance, while they will not
be reset on an X report issuance. Therefore, X reports may be taken at any time and any
number of times during the day or at the end of the day.
TABLE OF X AND Z REPORTS
REPORTNA«
MODE
WCK
.
* DAILY READ AND RESET
DAILY READ X
H [ATATLl 59
DAILY RESET (DEPARTMENT +
FINANCIAL + CLERK + GROSS PROFIT)
Z
PLU READ AND RESET
ALL PLU READ X
D [PLU]
ALL PLU RESET
z
ZONE PLU READ X
31
ZONE PLU RESET
z
63
* CLERK READ AND RESET
INDIVIDUAL CLERK READ X —j set the required Clerk
64
INDIVIDUAL CLERK RESET
z
J Key to ON -> 1 (AT/TL]
HOURLY RANGE READ AND RESET
HOURLY READ X
HOURLY RESET
z J
10 [AT/TL] 65
DEPARTMENT READ AND RESET
ALL DEPARTMENT READ X
^ 11
[ATfTL]
ALL DEPARTMENT RESET
z
66
DEPARTMENT GROSS PROFIT READ X 12 [AT/TL] 67
-57-