Cleaning the print head, Cleaning the print head 3 - 1 – Toshiba TEC EM1-31059 User Manual
Page 105
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
13. CLEANING THE PRINT HEAD
EM 1-31059
13. CLEANING THE PRINT HEAD
13. CLEANING THE PRINT HEAD
If the print head is dirty, clear printing will not be produced. It is recommended to clean the head with
thermal head cleaner everyday before starting operation using the following procedure:
1. Remove the printer cover and label cassette.
Then push the head-up lever in the direction
indicated by the arrow.
Head-up Lever
2.
Wipe off the dirt on the blackened portion in
the diagram to the right with the thermal
head cleaner.
Then set the label cassette, and push down
the print head.
NOTE: Be careful not to damage the print head
when cleaning.
3.
If any paste of the label applies on the label
cutter or printer cover, wipe off the paste
with alcohol.
Head
Thermal Head Cleaner
After removal of the Label Cutter, attach it in the following procedure.
1.
Install the Label Cassette, which label is not loaded into, on the Scale.
2. Install the Label Cutter aligning the Cutter Notches with the Screw Holes.
3. Secure the Cutter with the White Screws where the bottom of the cutter is 0.3 ~1 mm
above from the Peel-off Plate.
Label Cutter
NOTE: In case the Cutter scratches a Label while printing, enlarge the clearance between the
Cutter and the Peel-off Plate.
1 3 - 1