Toshiba TEC MA-1040-100 Series - Manual (Page 43)

REPLACING THE RIBBON CARTRIDGE
When the receipt and journal print is
too light, replace the ink roll in the
following manner:
1. Remove the Ribbon Cover (Fig. 1).
2. Remove the old ribbon cartridge by
pulling it toward you (Fig. 2).
3. Install a new ribbon cartridge in the
reverse order to Step 2 above (Fig.
3).
4. The ribbon cartridge is a comsumable
product. Be certain to use genuine
ribbon cartridge supplied by your TEC
representative
REPLENISHING THE STORE NAME STAMP WITH
INK
When the store name stamp is printed too
lightly, replenish the ink in the
following manner:
1. Turn the Power Switch to OFF. Remove
the Paper Cover.
2. Withdraw the store name stamp with
the protruding part pinched with your
fingers (Fig. 4)*
3. Apply ink on the pad on the rear side
of the Store Name Stamp. The amount
of the refilling should be addjusted
according to the density of the
printed message, but the limit of 2
cc should not be exceeded, (The ink
bottle supplied contains 5 cc of ink)
(Fig. 5)
4. Follow the reverse order of Step 2,
and then attach the cover.
Ink
Mg. 4 Fig. 5
- 45 -