Error message table, Before you call for service – Toshiba TEC SL57 SERIES User Manual
Page 29
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
13. ERROR MESSAGE TABLE
Take the following action if an error message has appeared on the total price display with the buzzer
sounding.
Message
Cause
Solution
H
Print head is not properly set.
Press key, and set the print head.
L
The label has run out.
Press key, and set a new label roll.
The label is not placed over the label
end sensors.
Press[^key, and setthe label correctly.
(Refer to Section 8.)
P
The label interrupts the label issued
sensors.
Press
key
and
FEED|
key.
Then
remove the label.
14. BEFORE YOU CALL FOR SERVICE
It is our primary concern to give you full satisfaction and better service. If, however, any problem arises
in connection with the operation of this scale, please check the following points once more before
calling for service:
A) Is the power plug fully inserted into AC outlet?
B) Is the power switch turned ON?
C) Is AC power being properly supplied to outlet? (Check it using other electric appliance.)
D) Check circuit breaker.
E) Has there been a power failure of any sort?
F) Has the operation been carried out in the correct order?
This scale has been manufactured under strict quality control. If you have trouble, however, DO NOT
TRY TO FIX IT BY YOURSELF. Pull the power plug out of the AC outlet, and contact your TEC
representative.
CAUTION:
The specifications are subject to change without notice.
- 26