Chrysler 2008 Country - Manual (Page 150)

WARNING!
Failure to comply with the following conditions
could result in serious injury or even death.
• NEVER place any child seat or infant carrier in the
Swivel ’n Go seat while it is in the rearward facing
position.
• The swivel seat should be locked in the forward
position when using any child seat or infant
carriers, with the vehicle in motion.
• Occupants riding in Swivel ’n Go seating, must be
wearing their seat belt and the seat must be locked
in either the forward or rearward position.
• Make sure the Swivel ’n Go seat is in a locked
position with the handle down. Test the seat after
it is locked to see that it doesn’t swivel.
Removing Swivel ’n Go Seating — If Equipped
1. Remove any obstructions from the floor behind the
seat, and stow the Third Row Seat.
2. Pull up on the release bar located at the bottom front
edge of the swivel seat.
3. From behind the seat, lift up on the rear of the seat
cushion while pulling the seat in a rearward direction.
4. Remove the seat from vehicle through the liftgate.
Rollers are part of the seat frame and will ease the
removal process.
5. Lower the release handle located at the bottom front
edge of the seat.
Each seat weighs about 90 lbs. (81 kg).
148 UNDERSTANDING THE FEATURES OF YOUR VEHICLE