Chrysler 2008 Country - Manual (Page 169)

the multifunction lever inward to the second detent will
cause the washers to spray for a maximum of 10 seconds,
or until the lever is released, and the wipers will cycle
three times.
NOTE: If the multifunction lever is depressed while in
the delay range, the wipers will operate for several
seconds after the lever is released, and then resume the
intermittent interval previously selected.
If the multifunction lever is depressed while in the off
position, the wipers will operate for approximately two
wipe cycles and automatically turn off.
2. Intermittent, Low and High Speed Wipers
Use the intermittent wipers when weather conditions
make a single wiping cycle, with a variable pause be-
tween cycles, desirable. Rotate the end of the multifunc-
tion lever to the first detent position, then turn the end of
the lever to select the desired delay interval. The delay
can be regulated from a maximum of about 20 seconds
between cycles, to a cycle every 2 seconds. The time delay
will be doubled if the vehicle speed is less than 10 mph
(16 km/h).
Low Speed is achieved by rotating the multifunction
lever past the intermittent settings, to the first detent.
High Speed is achieved by rotating the multifunction
lever past the intermittent settings, to the second detent.
3. Rotary Ring — Rear Wiper and Washer
Rotating the rotary ring to the first detent activates the
rear intermittent wipers. To activate the washers, rotate
the rotary ring fully forward and the washers will spray
until the ring is released, and then resume the intermit-
tent interval.
NOTE: Rear window wipers function in the intermittent
wiper speed only.
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 167
3