Uconnect™ voice command, Voice command for text messaging, Changing the volume – Chrysler 2011 200 - User Guide User Manual

Page 37: Warning

Advertising
background image

Uconnect™ VOICE COMMAND

• The Uconnect™ Voice Command system allows you to control your AM, FM radio, satellite

radio, disc player, Uconnect™ Phone, a memo recorder, and supported portable media devices.
The Voice Command system also provides limited capability to select and play music by artist,
song, album, music, genre, or playlist from your compatible iPod® device (this capability is
available for Media Center 430/430N when connected to the USB port).

• When you press the Voice Command button

located on the radio faceplate or

steering wheel, you will hear a beep. The beep is your signal to give a command. If you do not
say a command within a few seconds, the system will present you with a list of options. If you
ever wish to interrupt the system while it lists options, press the Voice Command
button

, listen for the BEEP, and say your command.

Voice Command for Text Messaging

• If equipped with Uconnect™ Voice Command, your Media Center 430N radio may be able to

play incoming SMS messages through the vehicle sound system.

• It also allows you to respond by selecting from various pre-defined phrases.

• Not all phones are compatible with this feature. Refer to the phone compatibility list at

chrysler.com/uconnect. Connected mobile phones must be bluetooth-compatible, and paired
with your radio.

Changing The Volume

• Start a dialogue by pressing the Voice Command button

, then say a command (for

example, “tutorial”).

• Use the radio ON/OFF VOLUME rotary knob to adjust the volume to a comfortable level

while the Voice Command system is speaking. The volume setting for Voice Command is
different than the audio system.

• For vehicles equipped with Video Entertainment System (VES)™, refer to the Uconnect™ Voice

Command section of the Uconnect™ User's Manual on the DVD for further details.

• For vehicles not equipped with VES™, refer to your vehicle Owner's Manual on the DVD for

Uconnect™ Voice Command information.

NOTE:

To access the tutorial, press the Voice Command button

. After the BEEP, say

“tutorial”. Press any hard-key/button or touch the display (Touch-Screen radio) to cancel the tutorial.

WARNING!

Any voice commanded system should be used only in safe driving conditions following
local laws and phone use. All attention should be kept on the roadway ahead. Failure to do
so may result in a collision causing you and others to be severely injured or killed.

ELECTRONICS

35

Advertising