Fog lamp, Rear tail, stop, turn signal, side marker, And backup lamp – Chrysler 2011 Country - Owner Manual User Manual

Page 520

Advertising
background image

3. Push the new bulb into the socket and reinstall the
socket by twisting until locked into the headlamp
housing.

Fog Lamp

NOTE:

Access to the fog lamp bulb is from the rear of

the fascia. On the left rear side of the fascia, remove the
push pin and lower the hinged access door on the air
dam.

1. From behind the bumper fascia, or the access panel on
the air dam, twist the bulb counterclockwise, and remove
bulb.

CAUTION!

Do not touch the new bulb with your fingers. Oil
contamination will severely shorten bulb life. If the
bulb comes in contact with an oily surface, clean the
bulb with rubbing alcohol.

2. Disconnect wire harness from the bulb.

3. Reconnect the wiring harness to the new bulb and
reinstall the bulb by twisting clockwise.

Rear Tail, Stop, Turn Signal, Side Marker And
Backup Lamp

1. Raise the liftgate.

7

MAINTAINING YOUR VEHICLE

517

Advertising
This manual is related to the following products: