Chrysler 2011 Country - User Guide - Manual (Page 23)

High Beams
• Push the lever away from you to activate the high beams.
• A high beam symbol will illuminate in the cluster to indicate the high beams are on.
NOTE: For safe driving, turn off the high beams when oncoming traffic is present to prevent
headlight glare and as a courtesy to other motorists.
Flash To Pass
• Pull the lever toward you to activate the high beams. The high beams will remain on until the
lever is released.
HEADLIGHT SWITCH AND HALO LIGHT SWITCH
Automatic Headlights/Parking Lights/
Headlights
• Rotate the headlight switch, located on the
instrument panel to the left of the steering
wheel, to the first detent for parking
lights
and to the second detent for
headlights .
• With the parking lights or low beam
headlights on, push the headlight switch
once for fog lights.
• Rotate the headlight switch to “AUTO” for
AUTO headlights.
• When set to AUTO, the system automatically turns the headlights on or off based on ambient
light levels.
SmartBeams™
• This system automatically controls the use of the headlight high beams. Refer to Programmable
Features in Electronics for further details.
Instrument Panel Dimmer
• Rotate the dimmer control to the extreme bottom position to fully dim the instrument panel
lights and prevent the interior lights from illuminating when a door is opened.
• Rotate the dimmer control up to increase the brightness of the instrument panel when the
parking lights or headlights are on.
• Rotate the dimmer control up to the next detent position to fully brighten the odometer and
radio when the parking lights or headlights are on. Refer to your Media Center/Radio User
Manual on the DVD for display dimming.
• Rotate the dimmer control up to the last detent position to turn on the interior lighting.
OPERATING YOUR VEHICLE
21