Warning – Chrysler 2011 Country - User Guide User Manual

Page 54

Advertising
background image

• Simultaneously, press and hold both the chosen HomeLink® button and the hand-held

transmitter button until the HomeLink® indicator flash rate changes from a slow to a rapidly
blinking light, then release both the HomeLink® and the hand-held transmitter buttons. This
may take up to 30 seconds, or longer in rare cases.

• Press and hold the just-programmed HomeLink® button; if the indicator light stays on

constantly, programming is complete and the garage door should open.

NOTE:

• Only use this transceiver with a garage door opener that has a “stop and reverse” feature as

required by Federal safety standards. This includes most garage door opener models
manufactured after 1982. Do not use a garage door opener without these safety features. Call
toll-free 1–800–355–3515 or, on the Internet, at www.HomeLink.com for safety information or
assistance.

• If you are having difficulty programming your HomeLink® and your garage door opener was

manufactured after 1995, you may have a rolling code. Follow the steps below for Programming A
Rolling Code System.

Programming A Rolling Code System

• At the garage door opener motor (in the garage), locate the “learn” or “programming” button.

This can usually be found where the hanging antenna wire is attached to the garage door
opener motor (it is NOT the button normally used to open and close the door).

• Firmly press and release the “learn” or “programming” button. The name and color of the

button may vary by manufacturer. Within 30 seconds, return to the vehicle and press the
programmed HomeLink® button twice (holding the button for two seconds each time). If the
device is plugged in and activates, programming is complete.

• If the device does not activate, press the button a third time (for two seconds) to complete the

programming.

Using HomeLink®

• To operate, simply press and release the programmed HomeLink® button and the programmed

device will operate.

• Refer to your Owner’s Manual on the DVD for further details. If you have any problems

programming HomeLink®, or require assistance, please call toll-free 1–800–355–3515 or, on the
Internet, at www.HomeLink.com.

WARNING!

• Your motorized door or gate will open and close while you are programming the universal

transceiver. Do not program the transceiver if people or pets are in the path of the door
or gate.

• Do not run your vehicle in a closed garage or confined area while programming the

transceiver. Exhaust gas from your vehicle contains Carbon Monoxide (CO) which is
odorless and colorless. Carbon Monoxide is poisonous when inhaled and can cause you
and others to be severely injured or killed.

ELECTRONICS

52

Advertising
This manual is related to the following products: