Ceiva 3 Digital Photo Receiver LF3000 - Manual (Page 27)

powerful resource that is available 24 hours a day, every day of the year. Loaded with information
about your personal Receiver, the Help library is a wealth of information and ideas.
You can also reach Customer Care via e-mail at [email protected]. If you don’t
have a computer, the CEIVA
TM Customer Care Team can be reached by dialing 1-877-
MYCEIVA (1-877-692-3482).
L O O K I N G F O R G I F T I D E A S ?
Don’t forget to visit the CEIVA Store at www.ceiva.com.
Check there frequently for special and great gift ideas!
Product Information
WARNING STATEMENT
( C F R 4 7 , § 1 5 . 1 0 5 , § 1 5 . 2 1 , a n d § 1 5 . 2 7 )
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15
of the FCC Rules.These limits are designed to provide reasonable protection against harmful interference in a residential
installation.This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accor-
dance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If the equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one of the following measures with respect to radios or televisions: • Reorient or relocate
the receiving antenna. Increase the separation between the equipment and Receiver. Connect the equipment into an
outlet on a circuit different from that to which the Receiver is connected. Ensure that card mounting screws, connector
attachment screws and all ground wires are secured and tight. Consult the dealer or an experienced radio/TV technician
for help.
Changes or modifications not expressly approved by CEIVA TM Logic, Inc. could void the user’s authority to operate the
equipment.This product was FCC certified under test conditions that included the use of shielded I/O cables and
connectors between system components.To be in compliance with FCC regulations, the user must use shielded cables
and connectors and install them properly.
P R O D U C T W A R R A N T Y 27
S H A R I N G M A D E E A S Y