COMP Cams 6100 Hi-Tech Belt Drive System - Manual

COMP Cams®
3406 Democrat Rd.
Memphis, TN 38118
Phone: (901) 795-2400 Fax: (901) 366-1807
www.compcams.com
Part #196
Revised 11/22/06
#6100 Hi-Tech™ Belt Drive System
Thank you for choosing COMP Cams® products; we are proud to be your manufacturer of choice.
Please read this instruction sheet carefully before beginning installation, and also take a moment to
review the included limited warranty information.
Note: These instructions begin with the previous cam drive system removed and the cam still
in the block. Rocker arms should be removed to facilitate easily rotating the cam itself. It is
also best to start a first time installation with the oil pan removed, since some interference
between the block and belt drive main plate may exist, necessitating repeated trial fittings of
the main plate.
INSTRUCTIONS
Kit Contents:
• Belt drive main plate with crank seal and
cam studs
• Main plate attachment bolts (10) 1/4”-20
• Belt
• Upper gear assembly
• Lower gear assembly
• Cam adapter
• Cam adapter bolts (3) 5/16”-18
• Upper gear retention bolt/washer (left hand
thread)
• Bronze thrust washers (2)
• Endplay adjustment shims (3)
• Cam retention plate assembly
• Cam retention plate locknuts (6) 1/4”-20
• Spanner wrench
Tools Required:
• Torque wrench
• Allen wrenches (5/16”,
5/32” & 1/4”)
• Crankshaft gear installer
#4933
• 5/8” socket & wrench
• Camshaft degree kit #4796
• Tube of RTV or suitable
replacement
• Small supply of motor oil
• Thread locker