Comtrol Hub DeviceMaster - Manual (Page 103)

DeviceMaster Installation and Configuration Guide: 2000594 Rev. A Managing the DeviceMaster - 103
Managing the DeviceMaster
This section discusses the following DeviceMaster maintenance procedures:
• Rebooting the DeviceMaster
• Uploading SocketServer to Multiple DeviceMasters on Page 104
• Configuring Multiple DeviceMasters Network Addresses on Page 105
Note: You can configure the network addresses for multiple DeviceMasters,
configure common settings for the DeviceMasters, and save the settings
to a configuration file that you can use to load settings up to all or
selected DeviceMasters.
• Adding a New Device in PortVision DX on Page 105
• Using SocketServer Configuration Files on Page 107
• Using Driver Configuration Files on Page 109
• Changing the Bootloader Timeout on Page 115, which discusses changing the
Bootloader timeout
• Managing Bootloader on Page 116, which also discusses checking the
Bootloader version and downloading the latest Bootloader
• Checking the NS-Link Version on Page 118
• Restoring Factory Defaults (2-Port, Only) on Page 119
• Accessing SocketServer Commands in Telnet/SSH Sessions (PortVision DX)
on Page 121
• Accessing RedBoot Commands in Telnet/SSH Sessions (PortVision DX) on
Page 125
Note: You can optionally refer to RedBoot Procedures on Page 129 if you want to
perform procedures at the RedBoot level.
Rebooting the DeviceMaster
There are many ways to reboot the DeviceMaster.
Method Procedure
PortVision DX
Right-click the DeviceMaster or DeviceMasters in the Device
List pane, click Advanced >Reboot and then Yes.
Note: If security has been enabled in the web page, you will
need to reboot the DeviceMaster in the web page.
Web page
Main page (Server Status): Scroll to the bottom of the page,
click Reboot and then Yes: Reboot.
Telnet Type reset.
DeviceMaster
2-Port Models
DeviceMaster 2-port models have a Reset/Restore switch.
• If the Reset/Restore switch is depressed for less than 2
seconds, the DeviceMaster 2-port models reboots.
• If the Reset/Restore switch is depressed for greater than
approximately 5 seconds it restores the DeviceMaster to
the factory default values.