Comtrol UP DeviceMaster Installation - Manual (Page 17)

Hardware Installation and Configuration Guide: 2000451 Rev. J Hardware Installation - 17
Hardware Installation
Mounting the
Embedded Use the following procedure to mount the DeviceMaster UP 1-Port Embedded with
the 5-30VDC power supply.
Observe proper ESD techniques when handling the DeviceMaster UP.
1. Carefully remove the DeviceMaster UP from the anti-static bag, following
standard electrostatic device handling procedures.
2. Mount the DeviceMaster UP for your environment using 1/4” stand-offs to
separate the DeviceMaster UP from the base.
3. Use one of the following methods to ground the DeviceMaster UP.
• Through the power supply by connecting the ground wire on the power
cable using plastic or metal stand-offs.
• Through the chassis, using metal stand-offs. If plastic stand-offs are used
to mount the board, then you must ground the DeviceMaster UP using the
power cable.
Note: The maximum diameter of the metal stand-offs should be 0.175” with a
4-40 machine screw. Metal stand-offs are not provided with the
DeviceMaster UP.
4. Optionally, attach the light pipes. The following light pipes have been tested
and found to function; Bivar, Inc. (P/N:LP-230) and Ledtronics, Inc.
(P/N:LTP003-0CW-001).
Caution
Non‐plated/non‐grounded mounting holes 0.116” diameter (+/‐0.003”).
WARNING: Holes in hatched area are not mounting holes.
Maximum component height above board is 0.55”.
Ethernet connection J2: J2 overhangs board edge by 0.14” and the height is 0.55”.
LED light pipe mounting holes. The LED light pipes are not provided.
Serial port connector J3: 0.1” pin spacing, 0.025” square pin diameter, and 0.230”
pin height.
Debug port connector J4: 0.1” pin spacing, 0.025” square pin diameter, and 0.230”
Power connector; the mating connector is Weidmuller P/N: 152651.
1
3
4
5
6
7
8
9
Plated/chassis grounded mounting hole 0.116” diameter (+/‐0.003”). 2
pin height.
5-30VDC Model
Caution