Comtrol UP DeviceMaster Filtering and Data Extraction - Manual (Page 23)

Chapter 5. Filtering Configuration Settings DeviceMaster UP Filtering and Data Extraction Reference Guide: 2000470 Rev. B - 23
5.3. RFID Reader Interface Type
This setting defines the expected RFID data format to be used while operating in RFID filtering mode. Each
Reader Interface Type is unique and pertains to the RFID reader manufacturer. If a different RFID reader is
to be used and it provides a similar format to any of the RFID Readers listed below, it can also be used in
RFID filtering mode.
• Unspecified: The DeviceMaster UP will assume a HEX ASCII format and will
attempt to locate the antenna number.
• Alien (Text Mode): Specifies the Alien RFID reader Text Mode.
• Alien (Terse Mode): Specifies the Alien RFID reader Terse Mode.
• Intermec (Hex ASCII Mode): Specifies the Intermec Reader returning data in the
Hex ASCII Mode.
See 3.2. Supported RFID Reader Formats on Page 14 for a detailed description of the RFID reader formats.
5.4. Barcode Formats
These settings define the barcode format to be
used for both standard and eight digit barcodes.
The term standard refers to UPC-A, EAN-13, JAN,
and EAN-14 barcodes which all have ten company/
product digits. The eight digit barcodes include
UPC-E and EAN-8 formats.
The standard and eight digit formats are selected
independently and each operates independently.
Note: The barcode filtering/data extraction will
not function if no format is selected.
Format
Numbering
Digits
Company
Digits
Product
Digits
Check
Digit
Standard Format
None N/A N/A N/A N/A
Company-5/ Product-5 1-3 5 5 1
Company-6/ Product-4 1-3 6 4 1
Company-7/ Product-3 1-3 7 3 1
Company-8/ Product-2 1-3 8 2 1
Company-9/ Product-1 1-3 9 1 1
Eight Digit Formats
None N/A N/A N/A N/A
EAN-8 Number-2/Product 5 2 0 5 1
EAN-8 Number-3/Product 4 3 0 4 1
UPC-E 1 Variable Variable 1
Standard barcode
web page interface
Eight digit barcode
web page interface