Overview, Discussed in – Comtrol ES7528 User Manual
Page 137
RocketLinx ES7528 User Guide: 2000509 Rev. C
Configuration Using the Command Line Interface (CLI) - 137
Configuration Using the Command Line Interface
(CLI)
Overview
The ES7528 provides in-band and out-band configuration methods:
•
Out-band management means that you configure the ES7528 using the RS-232 console cable and the
Command Line Interface (CLI) to access the ES7528 without attaching an admin PC to the network. You
can use out-band management if you lose the network connection to the ES7528.
•
In-band management means that you connect remotely using the ES7528 IP address through the
network. You can remotely connect with the ES7528 embedded Java applet web user interface or a Telnet
console and the CLI.
If you are planning on using in-band management, you need to program the ES7528 IP address to meet your
network requirements. The easiest way to configure the IP address is using a Windows system and PortVision
DX, which is discussed in
Configuring the Network Settings
If you want to use the web user interface for configuration, see
Configuration Using the Web User Interface
Use the following procedures to access the ES7528 using the CLI:
•
•
This section contains information about the following groups of commands:
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•