Command line interface introduction – Comtrol ES8510-XTE User Manual
Page 129
RocketLinx ES8510-XTE User Guide: 2000574 Rev. C
Command Line Interface Introduction - 129
Configuration Using the Command Line Interface (CLI)
If you selected SSH, click Yes.
•
Enter the user name (default = admin).
•
Enter the password (default = admin).
If you selected Telnet:
•
Enter the user name (default = admin).
•
Enter the password (default = admin).
All the commands you see in SSH are the same as the CLI commands you see through the RS-232 console.
Command Line Interface Introduction
The Command Line Interface (CLI) is the user interface to the ES8510-XTE embedded software. You can view
the system information, show the status, configure the switch, and receive a response back from the system by
keying in a command.
There are several different command modes. Each command mode has its own access ability, available
command lines and uses different command lines to enter and exit. These modes are:
•
on Page 130, which includes commands to ping or telnet to a remote device, and show
some basic information and to access Privileged EXEC mode
•
on Page 132, which provides a view current configuration, reset default, reload
switch, show system information, save configuration, and access Global Configuration mode
•
on Page 133, which you can use configure all ES8510-XTE features and access
to one of the Interface Configuration modes
•
(Port) Interface Configuration
on Page 134, which can be used to configure port settings
•
(VLAN) Interface Configuration
on Page 135, which can be used to configure the settings for a specific
VLAN
Refer to
Configuration Using the Command Line Interface (CLI)
on Page 125 to access the CLI.