Comtrol ES8510-XTE - Manual (Page 96)

96 - DSCP-Queue Mapping RocketLinx ES8510-XTE User Guide: 2000574 Rev. C
Configuration Using the Web Interface
DSCP-Queue Mapping
Use this page to change DSCP values to Physical Queue mapping table. Since the switch fabric of the
ES8510-XTE only supports four queues. Lowest, Low, Middle and High users should therefore assign how to
map DSCP values to the level of the physical queue. You should therefore assign how to map DSCP value to
the level of the queue. You can change the mapping table to follow the upper layer 3 switch or routers’ DSCP
setting.
After configuration, press Apply to enable the settings.
Note: You must Save the settings ( Page 123 ), if you want to maintain these settings if the ES8510-XTE is
powered off.