Comtrol AT Command Set Rev A - Manual (Page 121)

AT Commands Reference Manual
100722B Conexant 3-95
+PSS - Use Short Sequence
This command causes a calling modem to force either a V.92 short or full startup
sequence as defined by the +PQC command on the next and subsequent connections.
Syntax
+PSS=<value>
Defined Values
<value> Decimal number corresponding to the selected sequence.
0 The modems decide whether or not to use the
short startup procedures. The short startup
procedures can only be used if enabled by the
+PQC command. (Default.)
1 Reserved.
2 Forces the use of the full startup procedures on
the next and subsequent connections independent
of the setting of the +PQC command.
Result Codes
OK 0 - 2 in V.92 Mode (+MS=V.92)
ERROR Otherwise
Reporting Selected Values
Command: +PSS?
Response: +PSS: <value>
Example: +PSS: 0 For the default <value>.
Reporting Supported Range of Parameter Values
Command: +PSS=?
Response: +PSS: (<value> range)
Example: +PSS: (0,1,2)