Comtrol AT Command Set Rev A - Manual (Page 42)

AT Commands Reference Manual
Conexant 100722B
3-16
3.2.2 DTE-Modem Interface commands
The parameters defined in this section control the operation of the interface between the
DTE and modem.
E - Command Echo
The modem enables or disables the echo of characters to the DTE. The parameter value,
if valid, is written to S14 bit 1.
Syntax
E<value>
Defined Values
<value> Decimal number corresponding to the option.
0 Disables command echo.
1 Enables command echo. (Default.)
Result Codes
OK <value> = 0 or 1.
ERROR Otherwise.
Q - Quiet Results Codes Control
The command enables or disables the sending of result codes to the DTE. The parameter
value, if valid, is written to S14 bit 2.
Syntax
Q<value>
Defined Values
<value> Decimal number corresponding to the option.
0 Enables result codes to the DTE. (Default.)
1 Disables result codes to the DTE.
Result Codes
OK <value>= 0 or 1.
ERROR Otherwise.