Comtrol DM Primo - Manual (Page 11)

DeviceMaster Primo Hardware Installation 11
Electromagnetic Compliances
Electromagnetic
Compliances This table illustrates electromagnetic compliances for the Primo.
Other Specification
Information This table provides other data that you may require about the Primo.
Electromagnetic Compliances Status
EMC: (conforms to the following standards)
FCC Class B
EN55022: 1994 class B
EN61000-3-2: 1995 class B
EN61000-3-3: 1995
EN55082-1: 1997
EN61000-4-2: 1995
Contact Discharge 4kV, Air Discharge 8kV
EN61000-4-3: 1995
EN61000-4-4: 1995
AC/DC Power supply 1kV, Data/Signal lines 5kV
EN61000-4-5: 1995
AC/DC Line to Line 1kV, AC/DC Line to Earth 2kV
EN61000-4-6: 1995
EN61000-4-8: 1993
3A/m at 50Hz
EN61000-4-11: 1994
Yes
Safety:
EN60950
UL/CUL, TUV Yes
Yes
Topic Specification
External power supply adapter (if
provided):
Input line frequency
Input line voltage
Output voltage
Output current
Note: Any power source that
meets the output voltage
and current requirements
can be used.
See illustration at left.
60 Hz
100 - 120VAC
12 VDC
400 mA (minimum)
Processor type x186 or equivalent
Memory 512 KB
Baud rate/port range 50 bps - 230 Kbps
Ethernet host interface
(upstream and downstream)
10/100Base-T (10/100 Mbps - RJ45)
Serial interface
RS-232, RS-422, and RS-485,
Dip Switch Selectable
Network protocols
TCP, UDP, ICMP, Telnet, IP,
RTelnet, DHCP
Configuration:
Data bits
Parity
Stop bits 7 or 8
Odd, Even, None
1 or 2 (with parity setting of None)
SNMP support Monitoring only.
Power Connector
-
+
VDC