Casio XJ-S36 EN - Manual (Page 36)

Troubleshooting
E-36
POWER
TEMP
LAMP : Green steady
: –
: – A system problem has occurred, which may cause problems
with some functions. Turn off the projector, disconnect the
power cord from the projector and wait for all of the
projector’s indicators to go out. Next, reconnect the power cord
and turn the projector back on.
If the error occurs again when you turn power back on,
contact your retailer or nearest authorized CASIO Service
Center.
Press the [ESC] key to clear the warning message.
Message : A system problem
has occurred. Some
functions may not
operate correctly.
POWER
TEMP
LAMP : Green steady
: –
: –
Message : There is some
problem with the
system.
The audio function
may not operate
correctly.
POWER
TEMP
LAMP : Green steady
: –
: –
Message : There is some
problem with the
system.
Movies may not play
back correctly.
POWER
TEMP
LAMP : Green steady
: –
: – The USB connection was terminated because the device
connected to the USB terminal caused excessive current to
flow to the projector. Immediately disconnect the USB device
and press the [ENTER] key.
Message : This device is
defective.
Remove the device
immediately, and then
press the [ENTER]
key.
POWER
TEMP
LAMP : Green steady
: –
: – The USB connection was terminated because of a problem
with the USB port. To use the USB function, turn off the
projector and then turn it back on again.
If the error occurs again when you turn power back on,
contact your retailer or nearest authorized CASIO Service
Center.
Press the [ESC] key to clear the warning message.
Message : There is a problem
with the USB port.
POWER
TEMP
LAMP : Green steady
: –
: – Zoom and focus cannot be performed due to some trouble in
the optical drive circuit. Turn off the projector and then turn it
back on again.
If the error occurs again when you turn power back on,
contact your retailer or nearest authorized CASIO Service
Center.
Press the [ESC] key to clear the warning message.
Message : Zoom and focus
cannot be performed
for some reason. Try
turning the projector
off and then back on
again.
If this message
reappears, request
servicing.
Indicator/Error Message Description and Required Action