Crosman 2200W - Manual

• The airgun is correctly aimed when the front sight blade is positioned exactly in the center of the notch of the rear
sight. The top of the front sight blade should be even with the top of the notch in the rear sight. The bulls-eye should
appear to rest on the top of the front sight. (Fig. 4)
• When you are sure of your target and backstop, and the area around the target is clear, take the airgun "Off Safe" (see
Section 2.2) and pull the trigger to fire.
NOTE: You must follow the procedure for pumping, loading and firing your airgun each time you shoot. (see Sections 3-
5)
5.2 Sight Adjustment
The rear sight may be adjusted to shoot higher or lower (elevation). When moving the elevator, slightly lift the rear sight
and reset it on the desired notch in the elevator. (Fig. 5) Move the rear sight elevator back to make the pellet hit higher
on the target. Move the rear sight elevator forward to make the pellet hit lower on the target.
6. Removing a Jammed Pellet
• Do not reload the air gun.
• Point the airgun in a safe direction.
• Put the airgun "On Safe".
• With the airgun "On Safe", open the bolt by pulling
it all the way back, insert a .22 caliber ramrod into
the barrel and carefully push the jammed pellet
into the loading port. Do not try to reuse that pellet.
(Fig. 7)
• If you are not able to unjam your air gun by follow-
ing the unloading procedure, take no further action.
An Authorized Service Station will unjam your air
gun (no cost during the warranty period).
7. Maintaining Your Airgun
• Before you attempt to oil your airgun, make sure the gun is unloaded and air has been removed (see section 4.2.)
• Your airgun will maintain proper function longer if you oil it every 250 shots. Put 1 drop of Crosman 0241 Pellgunoil®
on the pump pivot pins and the pump
cup in the pump mechanism. (Fig 8)
DO NOT use petroleum distillate
based oil or solvent and DO NOT
over-oil as this can cause damage to
your gun.
• A light coat of Pellgunoil on the barrel
helps prevent rust.
• DO NOT MODIFY OR ALTER YOUR
AIRGUN. Attempts to modify the air-
gun in any way inconsistent with this
manual may make your airgun unsafe
to use, cause serious injury or death,
and will void the warranty.
• If you drop your airgun, visually check
to see that it works properly before you
use it again. If anything seems
changed, like a shorter or weaker trigger pull, this may mean worn out or broken parts. Call Crosman customer serv-
ice for assistance before using your airgun again.
8. Reviewing Safety
• Never point the airgun at any person or at anything you do not intend to shoot.
• Always treat the airgun as though it is loaded and with the same respect you would a firearm.
• Always aim in a SAFE DIRECTION. Always keep the muzzle of the airgun pointed in a SAFE DIRECTION.
• Always keep the airgun on safe until you are ready to shoot.
• Always check to see if the airgun is "On Safe" and unloaded when getting it from another person or from storage.
• Always keep your finger off the trigger and out of the trigger guard until ready to shoot.
• You and others with you should always wear shooting glasses to protect your eyes.
• If your reading or prescription glasses are not safety glasses, make sure you wear shooting glasses over your regular
glasses.
• Use the proper size pellet for your airgun. .22 caliber (5.5 mm) pellets will work in your model 2200.
• Never reuse ammunition.
• Do not shoot at hard surfaces or at the surface of water. The pellet may bounce off or ricochet and hit someone or
something you had not intended to hit.
• Place the backstop in a location that will be safe should the backstop fail.
• Your backstop should be checked for wear before and after each use. All backstops are subject to wear and will even-
tually fail. Replace your backstop if the surface is worn or damaged or if a ricochet occurs.
• Do not attempt to disassemble or tamper with your airgun. Use an Authorized Service Station. Using unauthorized
repair centers or modifying the function of your airgun in any way may be unsafe and will void your warranty.
• Always keep your CrosBlock® trigger block in place when storing this airgun. Store airgun in a secure location. (See
CrosBlock instructions packaged with this airgun for assistance)
• Before you store your airgun, make sure that it is unloaded, not charged, and that the airgun is "On Safe."
SPECIFICATIONS
Mechanism/Action Bolt-Action
Caliber/Ammunition .22 cal. (5.5 mm) Lead Airgun
Pellet
Weight 4 lbs. 13 oz. (2.18 kg)
Length 39 3/4 inches (101cm)
Congratulations and thank you for purchasing the CROSMAN® Model 2200. Please read this owner's manual completely.
And remember, this airgun is not a toy. Treat it with the same respect you would a firearm. Always carefully follow the
safety instructions found in this owner's manual and keep this manual in a safe place for future use.
If you have any questions regarding your new airgun, please contact Crosman at 1-800-7AIRGUN, 585-657-6161 or
www.crosman.com and ask for Customer Service.
Operating Procedures
Section 1. Learning the Parts of Your New Airgun Section 5. Aiming and Firing Safely
Section 2. Operating the Safety Section 6. Removing a Jammed Pellet
Section 3. Pumping the Airgun Section 7. Maintaining Your Airgun
Section 4. Loading and Unloading Pellets Section 8. Reviewing Safety
1. Learning the Parts of
Your New Airgun.
Learning the names of the
parts of your new airgun will
help you to understand your
owner's manual. Use this
manual to increase your
enjoyment of this airgun.
2. Operating the Safety
2.1 To Put the Airgun "ON SAFE":
• Locate the safety directly in back of the trigger.
• Push the safety from the left side all the way in (Fig.
1). The safety is not "On Safe" unless it is pushed all
the way in and the RED ring around the safety is NOT
showing.
Like all mechanical devices, an airgun safety can fail.
Even when the safety is "On Safe", you should contin-
ue to handle the airgun safely. NEVER point the air-
gun at any person. NEVER point the air gun at any-
thing you do not intend to shoot.
2.2 To Take the Airgun "OFF SAFE":
• Push the safety from the right side all the way in.
When you can see the RED ring around the left
side of the safety, the airgun is "Off Safe" and can be
fired.
3. Pumping the Airgun
• Put the airgun "On Safe". (See Step 2.1)
• Open the forearm all the way until it stops (Fig. 2). Be sure to hold the forearm
firmly as you open it. It could spring back into the closed position, possibly caus-
ing injury. Place your hands in the same positions shown in Fig. 2 in order to avoid
being pinched, should you lose hold of the forearm. Do not twist the forearm while
pumping. Use straight strokes to prevent breakage.
• Be sure to use at least three pumps (but no more than 10) to prevent the barrel
from jamming with a pellet remaining in the barrel after firing.
• Return the forearm to the original closed position with a smooth stroke. Be sure
to hold the forearm firmly as you close it.
Note: You must follow the procedure for pumping, loading and firing your air-
gun each time you shoot.
4. Loading and Unloading/Firing Pellets
4.1 Loading a pellet (use .22 caliber pellets only)
• Put the air gun "On Safe." (See Section 2.1)
• Point the air gun in a SAFE DIRECTION.
• Pull the bolt all the way back.
• Place one pellet (nose first), in the loading port. (Fig. 3)
• Push the bolt all the way forward. The pellet is now in a position to fire out of
the barrel.
4.2. Unloading Pellets
• The most common way to unload pellets is to fire your airgun in a SAFE
DIRECTION after following Section 5 on aiming and firing safely.
• With the air gun "On Safe" (See Section 2.1), pump the air gun three times
(See Section 3) and cock the bolt by pulling it all the way back and pushing it
forward.
• Take the air gun "Off Safe" (See Section 2.1), point the air gun in a SAFE
DIRECTION and pull the trigger to fire.
• Put the air gun "On Safe". (See Section 2.1)
• Another way of unloading the air gun is to follow the directions listed under
Section 6. - Removing a Jammed Pellet.
5. Aiming and Firing Safely
5.1 Aiming the Airgun
• Always point your airgun in a SAFE DIRECTION.
• Follow the instructions for pumping (Section 3) and loading pellets (Section 4.1)
• You and others with you should always wear shooting glasses to protect your eyes.
• Do not shoot at hard surfaces or at the surface of water. The pellet may bounce off or ricochet and hit someone or
something you had not intended to hit.
• Always choose your target carefully. For example, you may wish to shoot at paper bulls-eye targets that are attached
to a safe backstop such as the Crosman 850 Target Trap. A heavy blanket should be hung behind the target trap to
prevent ricochet should you miss the backstop.
• Your airgun is designed for target shooting and is suited for both indoor and outdoor use. Always remember to place
your target carefully. THINK about what you will hit if you miss the target.
YOU AND OTHERS WITH YOU SHOULD ALWAYS WEAR SHOOTING GLASSES TO PROTECT YOUR EYES.
READ ALL INSTRUCTIONS BEFORE USING.
BUYER AND USER HAVE THE DUTY TO OBEY ALL LAWS ABOUT THE USE AND OWNERSHIP OF THIS AIRGUN.
WARNING: Keep the airgun in the "ON SAFE" position until you are actually ready to shoot. Then push
the safety to the "OFF SAFE" position.
WARNING: Always hold the forearm firmly when pumping the forearm to prevent possible injury.
WARNING: Never pump your airgun more than 10 times. Over-pumping can cause major damage to
your air rifle. Pumping more than 10 times may also leave a small amount of air in the air rifle after it is fired which
may allow you to fire a second shot without additional pumping.
WARNING: Use .22(5.5mm) caliber pellets only in your Model 2200B. Never reuse pellets. Use of any
other ammunition can cause injury to you or damage to the airgun.
WARNING: Not a toy. Adult supervision required. Misuse or careless use may cause serious injury or
death. May be dangerous up to yards ( meters).
WARNING: Lead pellets. Do not inhale dust or put pellets in mouth. Wash hands after handling. This
product contains lead, a chemical known to the State of California to cause cancer and birth defects (or other repro-
ductive harm.)
Model 2200
.22 Caliber (5.5 mm) Pneumatic Airgun
OWNER'S MANUAL
READ ALL INSTRUCTIONS AND WARNINGS IN THIS
MANUAL BEFORE USING THIS AIRGUN
Crosman Corporation
Routes 5 & 20,
P.O. Box 308
E. Bloomfield, NY 14443
www.crosman.com
1-800-7AIRGUN
2200A515 B04
THIS AIRGUN IS INTENDED FOR USE BY THOSE 16 YEARS OF AGE OR OLDER.
SAFETY
Push in from left for "On Safe".
Push in from right for "Off Safe".
Fig. 1
Fig. 2
PELLET
Fig. 3
FOREARM
BOLT
LOADING
PORT
FRONT
SIGHT
BLADE
TARGET
REAR
SIGHT
Fig. 4
DOWN
UP
SIGHT
ELEVATION
Fig. 5
Fig. 6
WINDAGE
ADJUSTMENT
SCREWS
RIGHT
LEFT
REAR
SIGHT
Fig. 7
LOADING PORT
JAMMED
AMMO
ROD
Fig. 8
PERFORMANCE: Many factors can affect velocity, including brand of projectile, type of projectile, lubrication, barrel condi-
tion and temperature. We recommend the use of Copperhead®, Crosman® or Benjamin® .22 pellets with this gun. This
airgun ammunition is designed for use in your airgun.
REPAIR SERVICE
If your airgun needs repair, we recommend you take or send it to your nearest Crosman Authorized Service Station. DO
NOT ATTEMPT TO DISASSEMBLE IT! Your airgun requires special tools and fixtures to repair it. Any disassembly or
modification not performed by an Authorized Service Station will void the warranty.
A SPECIAL CUSTOMER SERVICE
Crosman Authorized Service Stations will unjam your airgun at no cost during the warranty period.
LIMITED ONE YEAR WARRANTY
This product is warranted to the retail consumer for one year from date of retail purchase against defects in material and
workmanship and is transferable. To register the serial number of your gun, please return the airgun registration form. The
warranty is not conditioned on the return of the card. You should retain the original sales receipt as record of date of pur-
chase.
WHAT IS COVERED
Replacement parts and labor. Transportation charges to consumer for repaired product.
WHAT IS NOT COVERED
Transportation charges to Authorized Service Station for product. Damages caused by abuse, modification or failure to per-
form normal maintenance - see Owner's Manual. Any other expense. CONSEQUENTIAL DAMAGES, INCIDENTAL DAM-
AGES, OR INCIDENTAL EXPENSES INCLUDING DAMAGE TO PROPERTY. SOME STATES DO NOT ALLOW THE
EXCLUSION OR LIMITATION OF INCIDENTAL OR CONSEQUENTIAL DAMAGES SO THE ABOVE LIMITATION OR
EXCLUSION MAY NOT APPLY TO YOU.
HOW TO OBTAIN WARRANTY PERFORMANCE
U.S. Customers- Locate nearest service station (see www.Crosman.com or call Crosman customer service at 800-724-
7486 for list of stations). The service station will give you details of how to proceed with sending the item in for repair. You
must contact the station prior to shipping your product.
Canadian Customers- Contact Crosman Parts & Service- 611 Neal Drive Peterborough, ON K9J 6X7. 705-749-0206.
International Customers- Please return product to your nearest distributor. If you do not know your distributor, please call
585-657-6161 and ask for our International Department for assistance.
IMPLIED WARRANTIES
ANY IMPLIED WARRANTIES INCLUDING THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A
PARTICULAR PURPOSE ARE LIMITED IN DURATION TO ONE YEAR FROM DATE OF RETAIL PURCHASE. SOME
STATES DO NOT ALLOW LIMITATIONS ON HOW LONG AN IMPLIED WARRANTY LASTS SO THE ABOVE LIMITA-
TIONS MAY NOT APPLY TO YOU.
To the extent any provision of this warranty is prohibited by federal, state or municipal law, which cannot be preempted, it
shall not be applicable. This warranty gives you specific legal rights and you may also have other rights, which vary, from
state to state.
BENJAMIN, CROSMAN, COPPERHEAD, PELLGUNOIL and CROSBLOCK are registered trademarks of Crosman
Corporation in the United States.
Sights Front: Fiber Optic
Rear: Fully Adjustable
Power Source: Pneumatic pump action
Safety: Cross bolt
Velocity: Up to 595 fps (181.4 mps)
Barrel: Rifled Steel