Digilent 410-183P-KIT - Manual (Page 2)

Basys3™ FPGA Board Reference Manual
2
15
2
14 13
3
4
5
6
8
7
11 9 12
2
10
1
16
Figure 1. Basys3 FPGA board with callouts.
Table 1. Basys3 Callouts and component descriptions.
A growing collection of board support IP, reference designs, and add-on boards are available on the Digilent
website. See the Basys3 page at
www.digilentinc.com for more information.
1 Power Supplies
The Basys3 board can receive power from the Digilent USB-JTAG port (J4) or from a 5V external power supply.
Jumper JP3 (near the power switch) determines which source is used.
All Basys3 power supplies can be turned on and off by a single logic-level power switch (SW16). A power-good LED
(LD20), driven by the “power good” output of the LTC3633 supply, indicates that the supplies are turned on and
operating normally. An overview of the Basys3 power circuit is shown in Fig. 2
.
Callout Component Description Callout Component Description
1 Power good LED 9 FPGA configuration reset button
2 Pmod connector(s) 10 Programming mode jumper
3 Analog signal Pmod connector (XADC) 11 USB host connector
4 Four digit 7-segment display 12 VGA connector
5 Slide switches (16) 13 Shared UART/ JTAG USB port
6 LEDs (16) 14 External power connector
7 Pushbuttons (5) 15 Power Switch
8 FPGA programming done LED 16 Power Select Jumper
Copyright Digilent, Inc. All rights reserved.
Other product and company names mentioned may be trademarks of their respective owners.
Page 2 of 19