Digilent 410-265P-KIT User Manual
Digilent Hardware
P
P
m
m
o
o
d
d
P
P
M
M
O
O
N
N
1
1
™
™
R
R
e
e
f
f
e
e
r
r
e
e
n
n
c
c
e
e
M
M
a
a
n
n
u
u
a
a
l
l
Revision: January 27, 2013
Note: This document applies to REV B of the board.
1300 NE Henley Court, Suite 3
Pullman, WA 99163
(509) 334 6306 Voice | (509) 334 6300 Fax
Doc:
502-265
page 1 of 2
Copyright Digilent, Inc. All rights reserved. Other product and company names mentioned may be trademarks of their respective owners.
Overview
The PmodPMON1 employs the Analog
Devices
®
AD5112 and ADM1191 to create a
system power monitor.
Features include:
•
monitor current draws less than 1.058A
•
monitor voltages from 3.16V to 26V on
the J3 VIN pin
•
DVDD input ranges from 3V to 5.5V
•
standard I
2
C interface
•
configurable device address allows for
up to nine PMON1s in a single system
Functional Description
Customers can configure the PMON1 to a wide
range of possible alert conditions from the
ADM1191 by using the configurable AD5112
potentiometer. The AD5112 upper
potentiometer connection ties to DVDD
through a filtering ferrite bead and the lower
connection connects to GND. (See Table 1 for
Connector Descriptions.) The wiper directly
connects to the SETV pin on the ADM1191 to
allow for the wide range of alert conditions. If
an alert condition occurs, LD1 on the PMON1
will illuminate and the alert pin will go to a logic
low state.
Using Multiple PMON1’s
In order to use multiple PMON1’s on a single
I
2
C bus, each individual PMON1 will need to be
connected; and the desired potentiometer
value programmed into the EEPROM on the
AD5112. Any stored value will become the
default starting value for the potentiometer.
The alert functionality available on the
ADM1191 will not function properly without
programming each individual device. (See
Table 2 for Jumper Descriptions.)
Device Configuration
For specific information related to device
configuration on the AD5112 and ADM1191,
please refer to the data sheets available at
www.analog.com
Connector J1 – Control Pins
Pin
Signal
Description
1,2
CONV
Trigger a conversion
3,4
ALERT
Overcurrent or
overvoltage event
Connector J2 – I2C Interface
1,2
SCL
Serial Clock
3,4
SDA
Serial Data
5,6
GND
Ground
7,8
DVDD
Input Voltage
Connector J3 – Power Monitor Screw
Terminal
1
VIN
Input voltage of device to
monitored
2
GND
Ground
3
VOUT
Voltage supplied to
device being monitored
Table 1. Connector Descriptions