DLE 40 - Manual (Page 2)

2
Parts List
(1) DLE-40 Gas Engine with DLE Carburetor
(2) CM6 Spark Plug with Spare Ignition Wire Springs
(2) Muffl er w/Gaskets
(4) 4x20mm SHCS (muffl er mounting)
(1) Electronic Ignition Module w/ Additional Tachometer Lead
(4) 25mm Engine Mounting Standoffs
(4) 4x30mm SHCS with 4mm Lock Washers & Flat Washers (propeller mounting)
(1) Silicone Pick-up Wire Cover / Ignition Wire Cover
(1) Red Three Pin Connector Lead w/ Pig Tail (for ignition switch)
(2) Three Pin Connector Securing Clips
(1) DLE Decal
Safety Tips and Warnings
● This engine is not a toy. Please place your safety and the safety of
others paramount while operating. DLE will not be held responsible
for any safety issues or accidents involving this engine.
● Operate the engine in a properly ventilated area.
● Before starting the engine, please make sure all components
including the propeller and the engine mount are secure and
tight. It is strongly recommended that a screw sealant is used
(Great Planes Threadlocker GPMR6060) during engine installation.
● During the break-in period, it is recommended that the engine be
installed on the aircraft or a test stand with an appropriate shock
absorber. Otherwise it is probable that vibration could rebound
back to the engine and serious damages may occur during the
break-in period. Break-in should be considered about the fi rst
3-5 gallons you run in the engine.