DLE 120 - Manual (Page 5)

5
Installation Instructions
Prepare the engine for installation
1. Check to see that all screws and bolts are tight. Check carefully for
any cracks, broken or missing parts. Tighten or replace any damaged
or missing parts before proceeding.
2. Install the silicone wire cover over the pick-up lead coming from
the engine (cut the excess silicone wire cover) and connect the lead
to the pick-up lead from the Electronic Ignition Module. Secure the
connection with the included three pin connection securing clips.
3. Connect the on/off switch lead to the red connector from the
Electronic Ignition Module using the lead from the on/off switch or
with the included three pin connector with pigtail. Use one of the
included three pin securing clips to secure the connection.