Dromida DIDC1150 - Manual

REQUIRED TOOLS
The following items are needed to install your Speed Kit.
✔ Phillips head screw driver
✔ 3/16" nut driver
✔ 1.5mm hex wrench ✔ 2mm hex wrench
✔ 2.5mm hex wrench
✔ Needlenose pliers ✔ Double sided servo tape (DTXR1215)
BRUSHLESS
SPEED KIT
INSTALLATION INSTRUCTIONS
Thank you for purchasing the Dromida Brushless
Speed Kit. It is strongly recommended to completely
read this manual before use. Damage resulting from
misuse or modification will void your warranty.
1. REMOVE STEERING LINKAGE
Using needlenose pliers, remove
the steering linkage from the
servo and the steering bellcrank.
2. REMOVE 2N1
Remove the 2N1 assembly
from the chassis. Unplug motor connector.
Remove antenna tube
from mount and slide
antenna through upper
chassis brace. Carefully
cut the tie wrap making
sure no wires are cut.
3. REMOVE UPPER CHASSIS BRACE
Remove the upper chassis
brace and spur gear cover
from the chassis.