Dromida DIDC1150 - Manual (Page 3)

7. INSTALL NEW BELLCRANK
8. INSTALLING BRUSHLESS MOTOR
Slide the bellcrank onto the shaft. Attach the
steering drag link using the screw removed
in step 6. Install the ball stud removed in
step 6. Snap the tie rod end that was
removed in step 5 onto the bellcrank.
Install the pinion onto the motor using the set screw removed in step 4. Make sure
that the pinion set screw seats on the fl at side. Using the washers removed in step
4 and motor screws supplied in the brushless speed kit, attach the brushless motor
to the motor mount. Note that the longer screw is used on the bottom as the motor
mount is thicker. Do not fully tighten the motor mounting screws at this time.
NOTE! The included pinions
must be used as follows:
MT4.18: 12T pinion
SC4.18: 13T pinion
BX4.18: 13T pinion
9. INSTALL MOTOR ASSEMBLY
Install the brushless speed kit motor assembly. Make sure the pinion
gear does not protrude past the spur gear. Set the gear mesh so that
there is a slight “rock” between the spur and pinion gears. Once the gear
mesh is set, tighten the motor mounting screws.