Christie Digital Systems P35GPS-MT - Manual (Page 32)

M a i n t e n a n c e
CHRISTIE DIGITAL SYSTEMS P35GPS Projector
March, 2004
5-7
3. Remove flexible shaft from dowser blade.
4. Remove two Allen head screws securing electric changeover assembly to mainframe.
5. Remove changeover assembly.
5 . 4 . 1 0 . R E M O V A L O F S H U T T E R D R I V E R A S S E M B L Y
Refer to item 7 in Figure 5-3 on page 5-4.
1. Relieve tension on outer timing belt (Section 5.4.2).
2. Relieve tension on inner timing belt (Section 5.4.3).
3. Relieve tension on shutter timing belt (Section 5.4.4).
4. Remove four Allen head screws securing shutter driver assembly.
5. Remove shutter driver assembly.
5 . 4 . 1 1 . R
E M O V A L O F
M
O T O R
A
S S E M B L Y
Refer to item 16 on page 2-3.
1. Disconnect motor's electrical leads at terminal block TB1-1 and TB1-2 (Figure 3-3 on
page 3-4).
2. Relieve tension on outer timing belt (Section 5.4.2).
3. Remove two cable ties holding motor cable in place by removing two Allen head cap
screws.
4. Remove four Allen head screws securing mounting plate with motor to motor bracket.
5. Remove motor assembly.
5 . 4 . 1 2 . R E M O V A L O F F A N
Refer to item 12 on page 2-2.
1. Remove four screws and washers securing fan to top plate of projector.
2. Pull fan up and remove A-C plug.
3. Remove fan.
5 . 4 . 1 3 . R
E M O V A L O F
F
R A M I N G
L
A M P
1. Open framing lamp door, which is secured by two quarter-turn fasteners (item 13 on
page 2-2).
2. Remove lamp as with ordinary light bulb.