EcoTech Marine MP40wES - Manual (Page 5)

STEP 6: Attach Wet Side
•
Place the wet side into the aquarium and allow ALL air to
escape from the propeller housing.
• Carefully align the wet and dry sides through the glass
(Figures F, G).
• Optional: Place the foam guard over the wet side of the pump.
The foam guard can be used to ensure that delicate marine
animals do not get caught in the nozzle.
6 7
Installing the VorTech
™
Continued
Figure F Figure G
STEP 7: Align Pump
• Plug the power supply into the driver. If the pump is not
already in Constant Speed Mode, press the MODE button
until the control dial is green.
• If there is vibration or excessive noise, carefully adjust the
propeller housing (wet side) by moving it very slightly left,
right, up or down until the noise/vibration is eliminated
or minimized (Figure H).
• Rotate the control dial clockwise
and set it to the maximum speed,
indicated by the blue LEDs.
• Press the MODE button to select
the mode of your choice and
then turn the control dial to the
desired flow rate.
Figure h
See page 9 for instructions on mounting the driver.