EDCO TMS-10 - Manual (Page 8)

Printed in USA
© 2004
TVW
Page 8
E-TMS10-I-0504
100 Thomas Johnson Drive, Frederick, MD 21702-4600 USA
Phone (301) 663-1600 • 1-800-638-3326
Fax (301) 663-1607 • 1-800-447-3326
Website: www.edcoinc.com • Email: [email protected]
Starting the Saw:
• Be sure blade is clear of item to be cut.
• Be sure cutting head is secured in cutting position.
• Turn motor power switch to on position and observe that motor comes to full speed before continuing.
Cutting:
• Place work piece on rolling table against the backstop and use the rolling table to move the work piece to the
blade. Do not strain the engine while cutting or jam work piece into the blade. Do not twist the work piece while
cutting.
• Do not reach underneath or around work piece while the blade is rotating.
• Keep stable footing at all times while cutting.
• Keep hair, clothing, fingers and all body parts away from the blade and any other moving parts.
• For wet cutting, maintain an adequate supply of water to cool the blade.
Note: If using the water pump, clean water must be run through the pump daily to avoid build up in the pump.
• When you have finished cutting, stop the motor by turning the motor power switch to the OFF
position. Do not leave the saw running unattended.
• Clean dust and debris from entire machine.
Possible Diamond Blade Problems
Figure 7
Refer to the
Rx for Diamond Blades
for more detailed information
on diamond blades.
IMPORTANT REMINDER: This machine is designed to use diamond blades to cut tile, and masonry
products. Do not use it to cut anything else.