T on inizio fase t on p33 p33, Humidification with humidity probe – EVCO CT1SA0040101 User Manual
Page 18
Advertising
Stop leavening specifications
CT1SA0040101
Vers. 1.11
18/36
T On
Inizio fase
T On
P33
P33
Where T On is the preset number of minutes of activation.
Humidity injection is inhibited if the temperature in the cell is lower than the value determined by parameter P31 for
both the automatic and manual cycles.
18.2. Humidification with humidity probe
You can enable the humidity probe by setting parameter P32 = zero.
The humidifier output switching on/off follows the following curve.
Setpoint-zm
Setpoint-zm-ist
Setpoint
Sonda Umidità
Setpoint-zm-bp
tempo
Umidificazione
Zona a reg. Propor
Zona a reg. Propor
Where:
Setpoint
is the preset humidity setpoint
Zm
is the dead zone for humidification (parameter P38)
Advertising