Default calibrations, Interface category – Expert Sleepers Silent Way v2.4.3 User Manual
Page 107
header on the ES-4/40/5 the expander is connected to.
Default Calibrations
‘Create ES-4 Calibration’ overwrites the cur-
rent calibration (if any) with a perfect 1V/
octave curve, assuming the ES-4’s hardware
factory calibration. The 0V point is set to
MIDI note 48 (C below middle C) - you may
like to use the Voice Controller’s Transpose
setting if this is not suitable for your needs.
You would almost certainly want to create a
calibration in this way if using ES-4 Mode (above). You could also use it when not in ES-4
Mode, if the output of the Voice Controller will be sent to the input of an ES-4 Controller
plug-in.
‘Create ESX-xCV Calibration’ overwrites the current calibration (if any) with a perfect 1V/
octave curve, assuming the ESX-4CV or ESX-8CV’s hardware factory calibration. Use this
when routing the Voice Controller’s output to the ESX-4CV Combiner or ESX-8CV Com-
biner plug-in, or when in ESX-4CV or ESX-8CV mode (see above).
Interface Category
The Interface Category drop-down menu allows you to inform the plug-
in of what kind of audio interface will be outputting the plug-in’s sig-
nal. Please refer to
for more details - the specifics are likely to be more fluid than should be put here in the
user manual.