Fieldmann FZN 2001-E - Manual (Page 11)

EN
ELECTRIC HEDGE TRIMMER USER'S MANUAL
10 Maintenance and storage
7. MAINTENANCE AND STORAGE
Use electric power tools, accessories, working tools, etc. according to these instructions in a manner
appropriate for the given type of electric power tool and take into consideration the work conditions
and the type of work that you will be performing. Using electric power tools for purposes other than
those for which they were designed may be dangerous.
Maintenance
Check whether the device is showing signs of wear.
Regular care for the machine will ensure not only a long lifetime and performance
Before use always visually check for worn or damaged parts.
Replace damaged or worn parts. To ensure that the machine always remains balanced, always
replace the entire set of the worn or damaged tools.
Worn or damaged machine parts may only be replaced at an authorised service centre or by the
vendor.
Before cleaning disconnect this product from the power source.
To clean the plastic parts of the product, use a soft cloth dipped in lukewarm water. Do not use
aggressive cleaning products and solvents as this could damage the surface of the product.
Do not clean the machine under running water or submerge under water.
Do not overload the electric power tool. Use the right type of electric power tool for your work. When
the correct electric power tool is used, the work result will be performed better and more safety.
If it is not possible to turn the main trigger switch on or off, do not work with the tool. All electric
power tools with a trigger switch that does not work are dangerous and must be repaired.
If you are not working with the tool, store it out of the reach of children and prevent persons not
informed about the operation of the tool or this user's manual to work with the tool. An electric
power tool in the hands of an unqualifi ed person is dangerous.
Maintain cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting edges
are less prone to jamming during work and are easier to handle.
Do not leave electric power tools turned on without supervision. Always turn the tool off and wait
for it to come to a complete stop before putting it down.
Use gloves when handling the trimmer's cutting blades or when cleaning it. After fi nishing work
inspect that the blades are tight and not damaged and the bolts on the cutting blade. If the
damage is serious, have the tool repaired by an authorised service centre or the vendor.
For repairs contact an authorised service centre or vendor who will use original spare parts. This
will ensure the correct operation of the electric power tool.
ATTENTION: Using any accessories or tools not designed for this machine may increase the risk
of injury. Always use only original spare parts.
Clean the tool after the completion of every work task.
Take proper care to prevent the motor from damage by oil or water.