Fieldmann FZF 4010-E - Manual (Page 11)

11
OPERATION MANUAL ELECTRIC GARDEN VACUUM CLEANER
EN Operation
Switching on and off
To switch the machine on, move the switch (3) to position “1”. (Fig. 5a).
To switch the machine off, move the switch (3) to position “0”. (Fig. 5b).
Speed control governor (Fig. 6)
Push the knob of the adjuster (a) from position “1” to position “6”; the speed will be adjusted
from 10,000 min-1 to 15,000 min-1; bigger figure means higher speed.
Blowing mode ( Fig. 7a)
Note: Blowing mode can be also used to clean corners, fences, walls, wooden areas or
beneath cars. Be careful where you point the jet of air as it could move heavy material or
cause injury or damage.
Turn the Function switch counterclockwise to the blow mode position.
Move the switch to ON position, point the jet of air in front of you and move slowly forward to
gather the leaves together or to move the leaves from inaccessible areas as shown in Fig.7a.
Vacuum mode ( Fig. 7b)
Set the Function switch clockwise to the vacuum mode position.
Make sure the collection bag is fitted properly.
Hold the blower/vacuum several centimetres over the leaves you are going to suck up. Now
switch the machine ON.
Hold the machine as shown in Fig. 7b, tilting the blower/suction tube slightly, and perform a
sweeping action to collect light debris with approximately 50 mm distance between the
blower/suction tube opening and the floor or ground to be clean up.
The leaves will be sucked up into the tube, chopped up and thrown into the collection bag.
When the collection bag is full, the vacuum power will be greatly reduced. When this happens,
turn the switch to position “0” (OFF) and disconnect the plug from the electricity supply. Wait
until the suction fan has stopped completely before operation. Open the zip fastener inside the
bag, spread out the opening and empty the bag completely. If you have collected only leaves or
vegetable matter, they will already have been shredded and will be ready for composting. Zip up
the bag and resume work.
Note: Before re-fitting the bag, clean the inside of the exhaust opening and remove any
shredded deposits. Pay special attention to the cleaning of the supporting edges of the air
flow deviator on the inside of the tube.
Electronic speed control setting (Fig. 6)
Your machine is completed with a speed control governor which allows you adjust the air
speed for various working conditions.