Fieldmann FDB 2005-E - Manual (Page 17)

EN
MULTI FUNCTION TOOL OPERATING INSTRUCTIONS
17 Speed control wheel | Flush cutting a door jamb and casing for installing flooting
PROJECT: ACCESSORY: SPEED:
Drywall Half circle blade Maximum
Restoring windows Half circle blade Medium
Door Jamb Wood blade Maximum
Door casing Wood blade Medium / Maximum
Wood dowels Wood blade Maximum
Floor vent Wood blade Medium / Maximum
PVC pipe Wood blade Medium
Glued flooring Scraper Medium
Sanding Scraper Medium / Maximum
WARNING : For safety reasons the operator must read the sections of this instruction manual entitled
GENERAL SAFETY INSTRUCTION, SPECIFIC SAFETY RULES and SYMBOLS before using
this multi-tool.
Verify the following every time the multi-tool is used:
Safety glasses, safety goggles, or face shield are being worn.
Hearing protection is being worn.
The blade or sandpaper is in good condition.
The accessory is properly tightened onto the accessory holder of the tool.
Failure to observe these safety rules will significantly increase the risk of injury.
5.4 FLUSH CUTTING A DOOR JAMB AND CASING FOR INSTALLING
FLOOTING
The multi-tool can be used to flush cut a door jamb and casing to allow space for the new flooring to fit nearly
under the door jamb and casing. For the purpose of demonstrating the procedure, floor tile is being used.
1. Install the plunge cutting wood saw blade for wood in the tool (Fig. 2).
NOTE: The blade should be centered on the tool housing and NOT installed in the 90° position.
2. Place a scrap piece of floor tile (1) on the floor about 1/2” (25mm) from the door jamb (2) (Fig. 7).