Fieldmann FDB 2002-E - Manual (Page 13)

13
OPERATING INSTRUCTIONS ELECTRICAL ANGLE GRINDER
EN Specific safety instructions | Use and operation
Do not use any reducers or other auxiliary parts for mounting grinding discs intended for
different spindle diameter.
Make sure that the material is adequately supported or fixed.
Never use grinding disc to remove burrs.
Make sure to prevent the sparks from hitting a person or igniting inflammable goods.
Do not work with the grinder if someone is standing in the line of the grinding disc. Make sure
to clean up the working area around you.
Press the locking knob of the disc (3) only after the engine and spindle of the grinder have
completely stopped !
Remember that the grinding disc will continue to rotate for a while after switching off the
grinder due to inertia.
Always use the auxiliary handle supplied with the tool.
Loss of control over the electric tools could cause injury.
WARNING!
Use means of protection against noise, dust and vibrations !!!
WARNING! Keep these safety instructions!!!
6. USE AND OPERATION
This angle grinder is intended for household or hobby use only.
The manufacturer and importer do not recommend using this tool in extreme conditions and
under high load.
Any other additional requirements must be agreed between the manufacturer and the
customer.
The machine is intended for cutting, grinding, rough-working and polishing of metals, stones
and ceramic articles, if a suitable disc is used.
Use the machine and attachments (note the manufacturer‘s specifications) only for the
intended range of applications.
Any other use is strictly forbidden.
Attaching the side handle (Figure B)
Mount the side handle (2) into one of the mounting holes.
How to attach and remove the safety guard (Figure C)
Unscrew the bolt of the safety guard fastening clamp (7).
Attach the safety guard (5) as shown in the figure (C) and tighten the bolt firmly.
Use reverse procedure to remove the safety guard.
WARNING! Never use the grinder without the safety screen.