Fieldmann FDB 2002-E - Manual (Page 14)

FDB 2001/2002-E
14 EN Use and operation | Working with angle grinder
How to attach and remove the grinding disc (Figure D,E,F)
WARNING! Before attaching or removing the grinding disc always unplug the supply cable
of the grinder from the socket.
Put the grinder onto table with the spindle facing up.
Attach the safety guard (5) according to instructions specified above.
Fit the washer (8) on the spindle (4).
Fit the grinding disc (9) on the washer.
Screw the tightening nut (10) onto the spindle.
Press the locking knob (3) and firmly tighten the tightening nut (10) using the Phillips
screwdriver.
If grinding disc is used, tighten the tightening nut (10) with the guiding lobe facing down (E1).
If cutting disc is used, tighten the tightening nut (10) with the guiding lobe facing up (E2).
WARNING! Press the locking knob of the spindle (3) only after the engine and the spindle
of the grinder have stopped and are not running!
You must hold the locking knob of the spindle (3) during the entire replacement of the disc.
Release the locking knob.
Use reverse procedure to remove the grinding disc.
Switching On and Off (Figure G)
Switch on the grinder by sliding the switch (1) to position “I”
Switch off the grinder by sliding the switch (1) to position “0”.
7. WORKING WITH ANGLE GRINDER
The optimum angle of disc to work piece is 150°.
Maintain the largest possible distance between the disc and operator.
Exert only slight pressure and no lateral load on the disc. Note the direction of rotation
and watch out for flying sparks.
Avoid knocking the work piece.
If the disc diameter is less than 80 mm, change the disc.