Flight of Harmony V’Amp Ver 1 Bare-Bones - Manual (Page 4)

4/9
Controls
Mod1: This is the magic knob, controlling the frequency mixing
as described in the introduction. Mod1 varies the amount that the Mod1
signal modulates the input signal, as well as controlling the polarity of the
output: positive from 7:00 to 12:00, negative from 12:00 to 5:00.
Mod2: This is the Mod2 input attenuator control.
Offset: Think of this as an internal gain control. The Offset can be used
to raise or lower the general level of the output signal, but it also can be used to
fine-tune the interaction of the various CV inputs. Try it, you’ll understand.
Input: This is the input level control. Just like a volume knob – clockwise
increases level, counter-clockwise attenuates the signal level.
Output: Output level control. Acts the same as the Input control.
Jacks
Inputs
Env in: Unattenuated VCA CV input.
Mod1: Modulator signal and/or CV input.
Mod2: Attenuated VCA CV input.
Input: Signal (or carrier) input.
Output
Output: The output jack.