Flintec DAS 72.1 User Manual
Process indicator type das 72.1 mark iii
Advertising
Table of contents
Document Outline
- C.4.1 System diagnosis Commands – ID, IV, IS, SR 30
- C.4.2 Set up Commands – SD, MT, GA, TE, TR, TL, AI 31
- C.4.3 Calibration Commands – CE, CI, CM, DS, DP, CZ, CG, AZ, AG, ZT, FD, CS 33
- C.4.4 Motion detection Commands – NR, NT 37
- C.4.5 Filter setting Commands – FM, FL, UR 38
- C.4.6 Set Zero/Tare and Reset Zero/Tare Commands – SZ, RZ, ST, RT 40
- C.4.7 Output Commands – GG, GN, GT, GS, GM, RM, GH, GO, GV, GW 42
- C.4.8 Auto-transmit Commands – SG, SN, SW, SM, SH, SO, SV 44
- C.4.9 Commands for external I/O control – IN, IO, OM, AI 46
- C.4.10 Setpoint Commands - Sn, Hn, Pn, An 48
- C.4.11 Communication setup Commands – AD, CL, BR, DX, OP, LI 50
- C.4.12 Commands Analogue Output 4 – 20 mA - AL, AH, AA 52
- C.4.13 Save parameters Commands – CS, WP, SS, AS, TH 53
-
- A GENERAL 2
- B KEYBOARD SET UP 4
- B.1 SHORT MANUAL OF KEYBOARD SETUP 5
- B.2 SETUP TABLE 6
- B.3 SET UP Flowcharts 7
- B.3.1 Zero set up, Menu 1.1 - 1.4 7
- B.3.2 Span set up, Menu 2.1 - 2.4 8
- B.3.3 Display set up, Menu 3.1 - 3.4 9
- B.3.4 Filter / no motion set up, Menu 4.1 - 4.4 10
- B.3.5 Analogue output set up, Menu 5.1 - 5.4 11
- B.3.6 Logic input set up, Menu 6.1.3 - 6.3.4 12
- B.3.7 Logic output set up, Menu 7.1 - 7.3 14
- B.3.8 Data communication set up, menu 8.1 - 8.4 15
- B.3.9 Error codes 16
- B.4 EXAMPLES 17
- D CE KONFORMITÄTSERKLÄRUNG 57
- C SETUP VIA SERIAL PORT 23