Flintec FT-10xx - Manual (Page 44)

FT-10 Smart Process Indicator, Technical Manual, Rev. 1.0, January 2014
P Print :Read the stable weight
Command : [ADR][P]
Response : [ADR][P][STATUS][SIGN][WEIGHT VALUE]
Example
:
Command : 01P
Response : 01PS+000123.4 (weight is stable and 123.4) or
01PN (could not print)
Comments :
Checks status and it must be stable. Else Nack status is send.
Status can be Stable or Nack.
Q Load set points
Command : [ADR][Q][SP No][SP Type][SIGN][SP VALUE]
Response : [ADR][Q][STATUS]
Example
:
Command : 01Q01L+000123.4
Response : 01QA (123.4 loaded to SP1_L)
01QN (Could not loaded)
01QX (Decimal point of SP VALUE is mismatch)
Comments :
SP Number is 2 byte ASCII char. Use 01 for SP1, 02 for SP2 and 03 for SP3.
SP Type is 1 byte ASCII char. Use ‘L’ for SPx_L and use ‘H’ for SPx_H.
SP VALUE data is 8-byte ASCII char with dot and non-significant zeros on the left.
R Read set points
Command : [ADR][R][SP No][SP Type]
Response : [ADR][R][STATUS][SIGN][SP VALUE]
Example
:
Command : 01R01L
Response : 01RA+000123.4 (SP1_L is 123.4)
01RN (Could not loaded)
Comments :
SP No is 2 byte ASCII char. Use 01 for SP1, 02 for SP2 and 03 for SP3.
SP Type is 1 byte ASCII char. Use ‘L’ for SPx_L and use ‘H’ for SPx_H.
SP VALUE data is 8-byte ASCII char with dot and non-significant zeros on the left.
S Read Status
Command : [ADR][S]
Response : [ADR][S][STATUS-1][STATUS-2][STATUS-3]
Example :
Command : 01S
Response : 01SSGI (Stable, Gross, In Range)
01SDGL (Dynamic, Gross, Low voltage error)
Comments :
The response includes 3 status information.
STATUS-1 can be Stable or Dynamic.
STATUS-2 can be Gross or Net.
STATUS-3
can be ‘In range’, ‘Out of range’, ‘+ Over’, ‘- Under’, ‘Low voltage’, ‘High voltage’ or ‘Errors’.
T Tare
Command :
[ADR][T]
Response : [ADR][T][A] (Taring is done successfully and scale is in net)
[ADR][T][N] (Taring could not executed)
[ADR][T][X] (Taring is disabled)
Comments :
The tare value is overwritten by the new tare weight value.
Status must be stable in 2 seconds time out delay. If so, Ack is send.
If it can not be stable in time out delay, Nack is send.