Flintec FAA-25 - Manual (Page 2)

FAA-25 Technical Manual, Rev. 2.08 January 2012 Page 2 of 10
WARNING !
The Error LED can be active before calibration. Do not care the error status before
performing the calibration of your weighing system.
Table of Contents:
1. Features .......................................................................................................................................................... 3
1.1. Technical Specification ........................................................................................................................... 3
1.2. Housing Dimensions .............................................................................................................................. 3
1.3. Model Identification ........................................................................ Fehler! Textmarke nicht definiert.
2. Installation and Commissioning ...................................................................................................................... 4
2.1. Mechanical Installation ........................................................................................................................... 4
2.2. Electrical Connections ............................................................................................................................ 4
2.3. Load Cell Connection ............................................................................................................................. 5
2.4. Analogue Output Connection ................................................................................................................. 5
2.5. Optional Digital Inputs / Outputs ............................................................................................................ 5
2.6. Optional RS232C Serial Interface .......................................................................................................... 5
2.7. Commissioning ....................................................................................................................................... 5
3. Operation ........................................................................................................................................................ 6
4. Setup and Calibration by using the Key Buttons ............................................................................................ 6
4.1. Setup of the Analogue Output Mode ...................................................................................................... 6
4.2. Setup and Calibration ............................................................................................................................. 6
4.2.1. Entering Setup & Calibration ............................................................................................................................. 7
4.2.2. Setup & Calibration ........................................................................................................................................... 7
4.2.3. Exit from Setup & Calibration ............................................................................................................................ 7
5. Setup and Calibration via Serial Interface ...................................................................................................... 8
6. Troubleshooting .............................................................................................................................................. 8
7. Declaration of Conformity ............................................................................................................................... 9
PRECAUTIONS
 DONT LET UNAUTHORIZED PEOPLE INTERFERE WITH THE INSTRUMENT.
 CHECK THE SUPPLY VOLTAGE, THE LOAD CELL AND ESPECIALLY THE
GROUND CONNECTIONS BEFORE ENERGISING FAA-25.
 DON’T ENERGISE FAA-25 BEFORE MAKING THE LOAD CELL CONNECTION.
 DON’T CONNECT / DISCONNECT THE CABLES AND/OR CONNECTORS WHILE
FAA-25 IS ENERGISED.
 DO NOT OPEN THE ENCLOSURE WHILE FAA-25 IS CONNECTED TO THE
POWER SUPPLY.