Flyzone FLZA3910 - Manual (Page 2)

™
flyzoneplanes.com
FLZA3910
OPTIONAL INSTALLATION OF
THE LANDING GEAR
RANGE CHECK
With the transmitter powered and the battery plugged into
the AirCore Module, walk 50’ [15m] from the aircraft and
check the control functions for proper and smooth operation.
FLYING THE AIRCORE AIRPLANES
Take off (or hand launch) directly into the wind.
Hand launch with throttle set at ¾ power, wings level and
with a slight toss (it is not necessary to aggressively throw
this model to hand launch it).
Once in the air, gain altitude to allow yourself suffi cient
reaction time to make a correction during fl ight.
Once you’re comfortable, adjust the aileron, elevator
and rudder trims one click at a time so that the AirCore
P-51 Mustang fl ies straight and level with the control
sticks centered.
You will quickly notice that the P-51 Mustang has the feel
of a larger R/C airplane. The airplane requires only small
amounts of control stick movement to fl y smoothly.
It’s recommended that you attempt to land before the motor
loses power and doesn’t have enough voltage to maintain
altitude. If you have a timer on your transmitter, set it for
4-minutes for the fi rst couple of fl ights. Then, gradually
increase the fl ight time to fi t your fl ying style. Allow at
least an extra 1-minute of fl ight time to allow for a second
attempt at landing.
If possible, always land directly into the wind.
Gradually reduce power when you are close to the landing
spot. When close to the ground and about to touch down,
pull the elevator stick back slightly to raise the nose of the
model and slow the landing speed to “fl air” for landing.
Unplug and remove the battery from the model and
switch off the transmitter. Allow the motor to cool
between flights.
REPAIRS
Repairs can be made to the AirCore P-51 Mustang by using
the following items:
● Formula ‘560’ Canopy Glue (highly recommended)
(PAAR3300)
● Thick Foam Safe CA (for quick fi eld repairs)
(GPMR6072)
● Foam safe CA accelerator (GPMR6035)
● Two sets of needle nose pliers or hemostats
(HCAR0625)
● Hobby Knife (#11 blade) (RMXR6900)
● Electric Flyer Hinge Tape (DUBQ0916)
REPLACEMENT PARTS
To order replacement parts for the AirCore P-51
Mustang Miss America, use the order numbers in the list
below. Replacement parts are available only as listed.
Replacement parts are not available from Product Support,
but can be purchased from hobby shops or mail order/
Internet order fi rms. If you need assistance locating a
dealer to purchase parts from, contact:
Product Support Phone: 217-398-0007
Fax: 217-398-7721
E-mail: [email protected]
Stock No. Description
● FLZA6410 AirCore P-51 Miss America Spinner
● FLZA6414 AirCore P-51 Miss America Fuselage
● FLZA6418 AirCore P-51 Miss America Wing
● FLZA6422 AirCore P-51 Miss America Hatch
● FLZA6426 AirCore P-51 Landing Gear
● FLZA6427 AirCore Airframe Push Rod Set
● FLZA6428 AirCore Hardware Set