Flyzone FLZA3006 - Manual

REQUIRED FOR COMPLETION
In addition to the items listed in the instruction manual for the
Rx-R edition, the Calypso ARF also requires the following items:
❍ 18A ESC (Electronic Speed Controller) (FLZA6011)
❍ C28-30 1300kV brushless motor (FLZA6012)
❍ Spinner, folding propeller set (FLZA6006)
❍ (4) Calypso micro servos (FLZA6013), or any of the
Futaba ® micro servos that have the same case as the
S3117 such as the following:
◗ S3117 (FUTM0417)
◗ S3157 (FUTM0657)
◗ S3156 (FUTM0656)
❍ (2) 18"–24" [460 mm – 610mm] servo wire extensions
for aileron servos (HCAM2200 for Futaba J)
❍ The ailerons may be mixed electronically through the
mixing in your transmitter, or “hard-wired” together into
the same channel with a Y-harness (FUTM4130).
❍ The Calypso may be assembled with just about any kind
of glue including foam-safe or regular CA, but for gluing
in the servos something thicker and fl exible is preferred
such as Zap Goo or similar (PAAR3200).
❍ A 1.5mm Allen wrench is required for tightening the set
screws in the folding propeller hub (DTXR0288).
❍ Non-permanent threadlocker for all metal-to-metal screws
(GPMR6060)
ASSEMBLY
Assemble the Wings
First, let’s center the aileron servo arms before gluing the
servos into the wing…
❏
1. Temporarily connect the aileron servos and ESC to your
receiver and turn on your transmitter. Making sure the trims
on your transmitter are centered, connect the battery to the
ESC. If necessary, remove and re-mount the servo arms so
they will be perpendicular as shown. Be certain to replace
the servo arm screws.
You may work on both wings simultaneously, or do one
wing at a time.
❏
2. Without using any glue, temporarily fi t the servos into the
pockets in the wing. Hook up the ailerons with the hardware shown.
❏
3. Connect a 18" – 24" [460mm – 610mm] servo extension
to the aileron servo wires and secure the connection with tape,
Manual Supplement
Refer to this Instruction Manual Supplement
for initial assembly of your Calypso ARF.
After completing the assembly steps in
this supplement, continue with the twenty-
page RTF / Rx-R / Tx-R Calypso instruction
manual booklet.